Watch the craftsmen at
JD2 Chassis
Build Lou Pilch's New Dragster


JD2 Chassis
starts every build with our in house
2D CAD design.
Cad Design
& 3D CAD design
3D Cad

Next we setup our chassis jig with the rear axle housing, dummy block & alignment fixture.
CHASSIS JIG

Now it's time to start the fabrication!
Here we are bending the top engine bay tube.
TUBING BENDER

Here we are notching tube on our mills
Vert. Mill

Horiz. Mill

This our chassis jig with some of the engine bay tubing located & ready to tack weld.
Tube in Jig

Some of our Chromoly tubing delivered from
Shapiro Supply Co.
JD2 Chassis will not use tubing imported from China in our chassis builds!
Tube Delivery

Lou's fiberglass body delivered from
Riggeal's Performance Fiberglass & Composites
Body Delivery


CHECK BACK OFTEN
ALSO CHECK OUT
OUR
PROJECTS & PRODUCTS PAGES >>>>>>>>>>>>

All contents of this site ©Jd2 LLC unless otherwise specified. Exclusions noted are sponsor logos, trademarks, and photos. Many photos on these pages appear courtesy of the following photographers: Michelle Drackett, Todd Dziadosz and Bruno Z. Motorsports.
Last modified: 22 Feb 06. Designed by Racing WebWorks.